INTERSECT command in CAD

INTERSECT command in CAD is the command to specify the intersection of Regions. The way to use the command:

  • Command line: Intersect
  • Menu: Modify / Solids editings – Intersect…

The way to use this command is similar to Subtract command in CAD but the result only keeps the intersection areas of Regions (below picture)

Picture – Using Intersect command
Picture – Using Intersect command

Good luck!

Thanks for reading!!!

You can see more useful writings about CAD… here

You might also like
Leave A Reply

Your email address will not be published.

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Accept Read More