Turning off the system of catching the point into Hatch in AutoCAD

Advertisements

Turning off the system of catching the point into Hatch in AutoCAD

Turning off the system of catching the point into Hatch in AutoCAD (catching the point of hatch): When using the system of catching the point in autocad, if you turn on many different systems of catching the point, it causes catching the point wrongly with the demand of drawer. Otherwise, the choice of object or defining the coordinates of hatch will be affected much because it takes long time to define the coordinates of catching the point. Moreover, in the process of dimensioning for object, if you do not turn off the system of catching the point with Hatch, it can cause the error because automatically catching the point will cause the error with coordinates of Hatch.

In this writing, we will introduce you the way to turn off the system of catching the point with hatch. Details are as below:

  • Command : Op ↵ => The dialog box “options” appears
Turning off the system of catching the point into Hatch in AutoCAD
Turning off the system of catching the point into Hatch in AutoCAD 
  • You choose Drafting => Pay attention to the item Object Snap Option => you click to Igonore hatch objects => then apply.
Turning off the system of catching the point into Hatch in AutoCAD
Turning off the system of catching the point into Hatch in AutoCAD

Good luck!

Thanks for reading!!!

You can see more useful writings about CAD… here

You can see more commands in AutoCAD… here

Advertisements

You might also like

Advertisements

Leave A Reply

Your email address will not be published.

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Accept Read More