RAY command in AutoCAD – Draw extension line in CAD

RAY command in AutoCAD is usually used as a command to draw extension line in CAD. This command is used to draw a half of straight line (across circle center)

• Menu: Draw –> Ray

You carry out this command similar to Xline command in CAD, but instead of drawing whole straight line, Ray command only draws a half of straight line from the first definition point.

• Command: Ray
• Specify start point: Choose the first point (start point)
• Specify through point: Choose the second point (the point orients for a half of straight line)
• Specify through point: Choose other point (the point orients for a new half of straight line across point (1)
• Specify through point: ↵ to complete the command

Good luck!

Thanks for reading!!!

You can see more useful writings about CAD… here