Turn off mode of tracking point to Hatch in AutoCAD

Advertisements

Turn off mode of tracking point to Hatch in AutoCAD

Turn off mode of tracking point to Hatch in AutoCAD (track point Hatch). When using mode of tracking point in AutoCAD, if you set many different regimes of tracking point => it causes tracking wrong point with the demand of drawer. Otherwise, selecting object or defining line coordinate will be also affected a lot because you have to spend long time to define coordinate to track point. Moreover, one problem often happens that in the process of Dimming dimension of object, if you do not turn off mode of tracking point with Hatch, it can cause error when you Dim because tracking point automatically will make mistake with coordinate of Hatch.

In this writing, we will guide you to turn off mode of tracking point with Hatch, details is as follows:

  • Command : Op ↵ => options dialog box appears.
Turn off mode of tracking point to Hatch in AutoCAD
  • You select Drafting => select Object Snap Option => Click to select at gonore hatch objects option => select apply.
Turn off mode of tracking point to Hatch in AutoCAD

Thank you for reading our writing!

You can see more useful writings about CAD… here

Advertisements

You might also like

Advertisements

Leave A Reply

Your email address will not be published.

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Accept Read More